I ran Evil Energy PTFE lines for my entire fuel system and THEN heard and read about the importance of using CONDUCTIVE PTFE for fuel as it’s much safer than non-conductive. So I ripped all of that out and ordered conductive lines from Evil Energy. I’m trying to install the fittings and it’s not nearly as easy to install as non conductive. It seems the inner liner of conductive lines is much thinner and not nearly as rigid as non conductive. Is there a special technique to get the Olive in the conductive PTFE lines without description the ultra thin inner liner?
Hi @TurboCharlie, thanks for the question. The installation method for both the standard and conductive models is the same. The thin wall is necessary to maintain a conductive layer and will not affect the installation.